Yamaha Rhino Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
3,228 Posts
Does he have a manual...

Start by isolating...disconnect wire going to solenoid and see if operating the switch with no load blows the fuse...

I never had this problem but think of it in it's simplest terms...

You press the button and it draws excessive current... start by being able to press the button with voltage to button but not to working load...

That cuts the problem in half...
 

·
Registered
Joined
·
1,131 Posts
Discussion Starter · #3 ·
Does he have a manual...

Start by isolating...disconnect wire going to solenoid and see if operating the switch with no load blows the fuse...

I never had this problem but think of it in it's simplest terms...

You press the button and it draws excessive current... start by being able to press the button with voltage to button but not to working load...

That cuts the problem in half...
Didn't think to unplug the other end first...good advice....thanks Craig !!
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top