Yamaha Rhino Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
2,617 Posts
Discussion Starter #1
So i went for a midnite ride lastnight and made it about an 1/8 mile out of the garage and bang!! Pushed it back home went to bed crying........ Just went out to check it out and its NOT good. Looks like half of the back side of the cases is gone!! You can see whats left of some of the piston and the rod haha yup you can see right in!! So the what to do now questions are starting.. What do you guys think is my best opion? Buy another 660 or just go with a rotax and be done with it? :feedback:
 

·
Registered
Joined
·
3,239 Posts
Been there and done that...

Your options...

1. Find a used 660/686 motor for sale from another rhino or grizzly...this is by far the cheapest, fastest and easiest route...and high performance 660 based built motors are available from time to time from those converting to rotax...

2. Find a good deal on an outlander or renegade quad with a good motor and do the swap...

Rebuilding your grenaded motor is NOT a wise choice and the least bang for the buck...

Obviously the rotax is the most expensive option and a ton more work but the results are GREAT...!
 

·
Banned
Joined
·
833 Posts
So i went for a midnite ride lastnight and made it about an 1/8 mile out of the garage and bang!! Pushed it back home went to bed crying........ Just went out to check it out and its NOT good. Looks like half of the back side of the cases is gone!! You can see whats left of some of the piston and the rod haha yup you can see right in!! So the what to do now questions are starting.. What do you guys think is my best opion? Buy another 660 or just go with a rotax and be done with it? :feedback:

that sux...didnt i just get a sheave from you
 

·
Registered
Joined
·
2,617 Posts
Discussion Starter #5
So i went for a midnite ride lastnight and made it about an 1/8 mile out of the garage and bang!! Pushed it back home went to bed crying........ Just went out to check it out and its NOT good. Looks like half of the back side of the cases is gone!! You can see whats left of some of the piston and the rod haha yup you can see right in!! So the what to do now questions are starting.. What do you guys think is my best opion? Buy another 660 or just go with a rotax and be done with it? :feedback:

that sux...didnt i just get a sheave from you

Haha ya it sucks bad! You can put your hole hand in the hole it made. No i have been wanting to send you mine just havent had time latley. Guess i have time now...:aargh4::aargh4:
 
1 - 5 of 5 Posts
Top