Yamaha Rhino Forum banner
1 - 2 of 2 Posts

· Registered
303 Posts
Discussion Starter · #1 ·
I decided it was time to adjust my valves yesterday and when I tried to remove the little plug that covers the timing marks, I stripped it out real bad. I had to use a chisle to break it lose. Are these available from any vendors on here, or should I just order it thru Yamaha? I'm guessing that it's not a standard pipe thread where I could just use a plug..?? Thanks.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.