Yamaha Rhino Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
10 Posts
Windshield specs

Spec's on mine are 50.125 wide x 34 tall x .1875" thick (these spec's allow for following the contour of the hood.) 30" tall will be adequate if you don't plan on following these contours. Also there is a angle bent at the top to parallel the roll cage that is figured into these specs. When folded down, the seam is 10.5" up from where the hood joint is. Hope this helps.
 

Attachments

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top