Yamaha Rhino Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
I have a 2006 660 and someone gave me a top from a 2008 700.
My Rhino is down at my place in Mexico so I cannot see if it fits.
I know the roll bar is different on the 2008 down lower, but is the upper part—where the roof will mount—the same?
I do not want to bother to haul it down there if it does not fit.

Thanks in advance,

-Andrew
 

·
Registered
Joined
·
105 Posts
I was given a roof off of a 2009 700 , when i went to install I didnt like the way it fit my 05 660
with the light bar i was using I moved it to the rear 3 inches ,, i bought 4 # 1 1/2 muffler clamps and just moved the roof so it would set farther to the rear .redrilled the roof with a 1/4 inch drill bit ,used bed liner to spray and seal the roof and then just mounted the roof , I also took out 1 1/2 of the front of the roof so i had clearance for the the light bar as need for fit and adjustments . it's better to have a roof than have not ..
Jake






 

·
Registered
Joined
·
105 Posts
on the front rack , I will ck and see if it has a name on it . it was on my Rhino when i
bought it ,, I did make my back bumper , bed rails & tail light guards
Jake
 
1 - 5 of 5 Posts
Top