Yamaha Rhino Forum banner

Rhino 450 Middle Shaft Nut

2K views 4 replies 3 participants last post by  Chalkminer 
#1 ·
I am reassembling my Rhino after replacing the rear driveshaft seal (engine side). Everyone says to use Loctite on the nut but do I use Red or Blue Loctite??
 
#2 ·
Red, prolly wouldent hurt to use the hi temp red. Blue is for smaller stuff


Sent from my iPhone using Tapatalk
 
#4 ·
Red is fine just use heat on the nut before u remove it. Would rather worry about how im gonna get it off rather than if its gonna come loose


Sent from my iPhone using Tapatalk
 
  • Like
Reactions: jimclemjr
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top