Yamaha Rhino Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
340 Posts
Discussion Starter · #1 · (Edited)
Race Rhino *Parting Out*

Hey guys, Im curious to see if anyone is interested in my chassis if I part out my rhino.. chassis is a low mileage chassis. raced only a few times. will sell stripped minus, all aluminum panels, including dashboard, hood, bedsides. setup for a rc51 street bike motor. clean and clear title and registration

$1800 for chassis

2003 rc51 motor. wiring is all stripped down to simplify things. motor still runs and everything. will sell with fuel pump, filter, exhaust, intake setup, air filter, wiring and gauge cluster.

$1800 for complete motor swap

located in so.california..

949 742 O156
 

Attachments

·
Registered
Joined
·
340 Posts
Discussion Starter · #2 ·
Looks like this thing might be getting parted out guys... Let me know if anyone is interested in any of these parts...

-2003 rc51 rvt 1000 v-twin motor with fuel pump and filter 1800
-toxic rhinos long travel kit +6. Brand new summers brothers axles. 2000 (or 2700 with shocks)
-ITP type 7 12" beadlocks with 26" Goodyear mtr tires on the front and Maxxis in the rear. 700
-complete chassis comes with dash, aluminum panels, bedsides, hood etc.. 1500
-radiator ron davis 12 3/4" x 22". Has at most 30 miles on it. 1" inlet and outlet 450
-seats/harnesses 400 Beard super seats and crow 3" padded harnesses ( not a direct replacement seat) 400
-gauges autometer 2" silver faced gauges, fuel level, water temp and volts. all all electric gauges. 100 for all 3 gauges.
-shocks 19.5" extended length (standard rhino +6 long travel shocks) 800
-fuel safe fuel cell 13 1/2"x 13 1/2" x 8" 7 gallon capacity has a sending unit on it. only ever had 91 octane in it. 450
-Gearone rear sprocket carrier Brand new. had a sprocket water jet for it. that is also included.. 350
-HCR spindles, setup for heims on upper and lower arms.low mileage not bent or anything. 400
-Gearone steering rack setup for heim steering 400
-set of factory rear hub convertd to 930 cv cups never used 200
-another set of type 2 converted rear stubs. 100
-rear spindles 125
-CNC clutch pedal 3/4" master cylinder, hanging pedel forward swing. 100
-2.0 x 10" king bypass shocks. have 30 miles max on them 650
-Brand new 930 axles from summers brothers. they are 21 7/8" clip to clip. 250
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top