Yamaha Rhino Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter · #1 ·
I am looking for 1 660 or 686 motor for a friend. His rod went through his case so his is pretty much shot.

If anyone has a good bottom end on a motor we would also be interested in that as well for a rebuild.

Any help would be appreciated, Happy New Year!

Reese Bettencourt
[email protected]
702-241-7960
 

·
Premium Member
Joined
·
7,795 Posts
686

I have a fresh 686,forged wiseco piston,HD HR rod,welded and gusseted middle drive support,all fresh and has about 18 hours on it,crank pin is welded, all rebuilt stock head and cam,cometic headgasket..so cal area,$2500.........714-883-6171.....if he's not familiar with having the middle drive support welded have him do some searching and talking around, its a major weak spot in the rhino cases and is a major strength inhancer for longevity when considering an engine rebuild..
 

·
Premium Member
Joined
·
7,795 Posts
x

I have 3 motors,that over the next year I'm rebuilding and running in my rhino to test them out and then sell them off, I'm in garden grove,california.

cases are a matched set from yamaha......
 
1 - 6 of 6 Posts
Top