Yamaha Rhino Forum banner
1 - 13 of 13 Posts

·
Registered
Joined
·
306 Posts
Discussion Starter · #1 ·
Anyone ever thought about making their rhino narrower?
I'm talking ,taking the body off and cutting the frame ,so at the wheels it would be no more than 48"- 50" wide at the wheels and fenders.
Some of the trails we ride on, the rhino, has to bypass due to width.
 

·
Registered
Joined
·
91 Posts
You could probably narrow it up an inch or 2 by getting some narrow wheels or pulling the spacers. But cutting it in half and rewelding?

Take the time you think you would have spent doing this, get a second job and use that money to buy a quad or something else.
 

·
Registered
Joined
·
91 Posts
Then why did you ask the question? :) The hardest part of the swap is going to be cutting and rewelding the axles.

You might have to go with different, narrower seats too. The easiest way to do it would be to cut an even amount off each side, not out of the middle. I think a Rhino is 54" wide right? 2" off each side. Done.

You're not going to like the finished project though.
 
1 - 13 of 13 Posts
Top