Yamaha Rhino Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
82 Posts
Discussion Starter · #3 ·
Ok thanks ill look it up. Reason I ask is I bougt some used trinity spindles with lower ball joints to replace the broken stock spindle. But they welded up a washer where the ball joint clip mounts in the stock spindle and the lower arms run heims so im looking for a fix basically...
 

Attachments

·
Registered
Joined
·
82 Posts
Discussion Starter · #5 ·
Do they make a mid travel kit? Their shock mounts to the upper a arm. The one we have is a longer dual rate walker evans shock the mounts to the lower a arm
 

·
Registered
Joined
·
82 Posts
Discussion Starter · #9 ·
Is there any type of spacers for a ball joint spindle?
Yeah, see my post above. The Uniball replaces the ball joint. You just need the spacers that go in the spindle. Any vendor that sells a uniball lower a-arm should be able to get you the hardware.
Sorry read that too fast. Thanks for the info ill be calling around
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top