Yamaha Rhino Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
13 Posts
Discussion Starter · #1 ·
Hey guys, in the middle of fabbing up some doors for my Rhino. I am having a hell of a time trying to come up with a good solution for the latches. I would love it if I could figure out some sort if easy way to secure the doors. So far I haven’t cane up with anything satisfactory. I’ll post some oics of what I am looking at. Hoping some of y’all could share your wisdom.

thanks!

Wheel Tire Hood Automotive tire Tread

Shelving Automotive tire Automotive exterior Shelf Wood

Tire Wheel Automotive tire Hood Motor vehicle

Automotive tire Bumper Automotive exterior Wood Rim

Wheel Tire Motor vehicle Hood Automotive tire
 

·
Registered
Joined
·
13 Posts
Discussion Starter · #8 ·
Finally got around to posting the finished pictures of my doors. As for the door latches i just welded a bar on either end of a piece of all thread and welded a nut to either side of the door. Works well. For insulation i just used foam board.

Tire Wheel Land vehicle Vehicle Car

Sky Plant Cloud Hood Automotive design

Wheel Sky Automotive parking light Tire Car

Tire Car Combat vehicle Hood Automotive tire
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top