Yamaha Rhino Forum banner

1 - 19 of 19 Posts

·
Registered
Joined
·
609 Posts
Discussion Starter #1
I have multiple gorrilla axle shafts for sale. I have 2 inner front cv joints that are in good condition on axles. They are for a 6" kit and some for a 6.5" kit. They all have good splines some have chips missing from the end where the c-clip goes but shouldnt affect them at all. I am looking for $25 each.....

Located in Prescott Valley Az
 

Attachments

·
Registered
Joined
·
431 Posts
Are all 4 corners of the +6 shafts the same length/ same splines/ interchangable on a 5006? Sorry, NOOB ????
 

·
Registered
Joined
·
609 Posts
Discussion Starter #3
No they aren't, im pretty sure the fronts are interchangable and are the same length. The rears are different lengths from left to right
 

·
Registered
Joined
·
452 Posts
I have an 07 660 with the Lonestar XTR 6.5" kit on it. I'm in need of rear axles. Will these fit my Rhino? Any idea what CV's would run for these? Thanks
 

·
Registered
Joined
·
609 Posts
Discussion Starter #5
I have an 07 660 with the Lonestar XTR 6.5" kit on it. I'm in need of rear axles. Will these fit my Rhino? Any idea what CV's would run for these? Thanks[/Q

Im not exactly sure how much cvs were, gorrilla would be able to get you price. I can assure you that they are very proud of there cvs and they arent cheap
 

·
Registered
Joined
·
16 Posts
Do you have any of the Gorilla shafts still available? I need driver side rear and should be around 23 inch. I have a +6 SoCal LT
Thanks
 

·
Registered
Joined
·
609 Posts
Discussion Starter #7
Do you have any of the Gorilla shafts still available? I need driver side rear and should be around 23 inch. I have a +6 SoCal LT
Thanks
Are you still in need of an axle? I can check and see if i have one that length right now....
 

·
Registered
Joined
·
16 Posts
Sorry for the delay! Can you check to see what size Gorilla axle you have left. I believe mine is 23 inch's for the Left Rear. And do you have any rebuild kits or complete cv for the inner rear?

Thanks
 

·
Registered
Joined
·
16 Posts
Yes I still need a left rear axle that is 23 inches long and do you also have the inner cv or a rebuild kit? I am going up to Flagstaff on thursday and could pick up if you still have one.

Thanks
Scott
 

·
Registered
Joined
·
609 Posts
Discussion Starter #13
I need to know length in inches to know if I have the right ones
 

·
Registered
Joined
·
74 Posts
I need a right front inner cv. Have one? shipped to 31757? And do you think it will fit a rhino brand shaft?
 
1 - 19 of 19 Posts
Top