Yamaha Rhino Forum banner
1 - 2 of 2 Posts

12 Posts
Discussion Starter · #1 · (Edited)
I went through and upgraded my fuel system. Basically, I broke the top off my pickup tube and had to do at least part of this. I had already installed the fuel float, but had not wired it yet. I used an 11 inch tube type float so I’ll have a slight reserve if necessary. All my parts were purchased from Amazon and arrived quickly. I ran all new hoses and bought a brass Y fitting for the return line.

Fuel sender andpickup tube
Wood Gas Motor vehicle Machine Wire
View attachment 65156
electric fuel pump
Motor vehicle Automotive tire Automotive fuel system Automotive exterior Gas

Fuel and temp gauge.
Right now, everything runs off that switch by the gauges. I need to find another power source that’s dependent on the key.


1 - 2 of 2 Posts