Yamaha Rhino Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter · #1 ·
I have an '08 700. Thought I had a cv going bad. pass. side axel turns fine. Drivers side turns hard and feels like it is grinding. Pulled the axel.
rotating the "hub" the cv joint goes into. That is where my problem is. Thought/ suggestions?
The hub/shaft going into the front diff won't just pull out. Do I have to pull the whole diff and split it? If so, any one have an '08 service manual?

thanks in advance!
Scout
 

·
Registered
Joined
·
138 Posts
Both of mine do it, I think its normal. The ring and pinion are on the left side of the diff so it should have more resistance but it feels notchy me. But practically everyone I know says theirs feel the same way.

Tim
 
1 - 3 of 3 Posts
Top