Yamaha Rhino Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
674 Posts
Discussion Starter #1
I have an engine code 14 show up today...it has showed up a few days ago as well. I have a 2008 700 with dual exhaust and VDI ecu, the bike is snorkeled with 1 1/2 inch pipe on the intake and 2 inch on the clutch, it has been snorkeled for 2 years. This is the only 2 times i have ever had the engine light come on with this code. When it is on the bike will die as soon as you press the throttle, but you can kill the bike and start up and it will do it a few times and then it is back to normal again without the code and running right. any help appreciated
 

·
Registered
Joined
·
581 Posts
Code 14 is Intake Air Pressure Sensor. Check to see if it is damaged. You can also test its output voltage to see if it is bad.

Nate
Alba Racing
 
1 - 6 of 6 Posts
Top