I have a 2007 rhino and I'm fairly new to the sport when I purchased the rhino I went over everything to make sure it worked and it did. The other day I went out for a short ride and try to engage the differential lock and could not. The cover that you slide over to engage the differential lock will not move to the side so you can engage differential lock is a common problem? Can anybody please help me with this?
Differential lock will not engage
1 - 4 of 4 Posts
Joined
·
39 Posts
Read the link below. Spray the **** out of it with WD-40, and if that doesn't free it up, then you will need to take it apart. Oh, and welcome to the forum!!!
http://www.rhinoforums.net/how/30820-4-wheel-diff-enguage-switch-stuck.html
Good luck
http://www.rhinoforums.net/how/30820-4-wheel-diff-enguage-switch-stuck.html
Good luck
Joined
·
336 Posts
common problem.
1) if you remove the switch from panel you will see screws on backside to take apart. Beware though small spring / ball bearing can and will be a handfull. Make sure you do not loose or misplace or get out of order.
or
2) as previosly mentioned wd40/jigaloo the heck out of it until you disolve/flush the offending dirt from the mechanism
1) if you remove the switch from panel you will see screws on backside to take apart. Beware though small spring / ball bearing can and will be a handfull. Make sure you do not loose or misplace or get out of order.
or
2) as previosly mentioned wd40/jigaloo the heck out of it until you disolve/flush the offending dirt from the mechanism
1 - 4 of 4 Posts
Join the discussion
