Yamaha Rhino Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
19 Posts
Discussion Starter · #1 ·
I was wondering what you guys are doin to change the cv boots on gorillia axles? They say you have to beat them apart. But there has to be an easier way. Any ideas would be great.
 

·
Registered
Joined
·
1,488 Posts
we have yet to find an easier way to get them apart. Gorilla says "tap with a wooden or rubber mallet". take it from me, this doesnt work. You have to beat on it pretty good. The best way is to put into vise, using a brass mallet on one side of the cv and a regular hammer on the other to try and offset the blow so you support the back side. Good luck.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top