Yamaha Rhino Forum banner
1 - 3 of 3 Posts

30 Posts
Discussion Starter · #1 ·
I bought a used low hour (supposedly) stock clutch a few months ago for my 2005 660 and am just now getting around to installing it. I noticed the clutch housing has a couple of nicks in it. Will this cause a problem, or will the clutch pads smooth this out? I used some emory cloth to try to smooth them out.

So what do you guys say: Install it or pop the $$ for a new housing?

Pics attached


1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.