Yamaha Rhino Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
282 Posts
Erik,

Off the top of my head, I can't really give you any advice. I have a couple odd size sockets laying around..I know one is a 27, and one is a 32mm. One fits my R6 rear wheel axle nut, and I believe it also fits the axle nut on the Rhino. Wish I could remember which one it is though...for some reason I think its the 32mm(also translates to 1 1/4" standard)

I had a hell of a time the first time I changed the rear brakes on my rhino...took me every bit of two hours or more. Nothing would come loose, piston on caliper was seized and then I just couldn't get things back in place. And im not exactly mechanically retarded either...must have just been one of those days. I would rather replace an axle than replace brake pads.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top