Yamaha Rhino Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
43 Posts
Discussion Starter · #1 ·
I pulled the carb and cleaned it up, it has been sitting for a couple months. Figured cleaning it would cure the problem but no luck. I idles fine when the choke is pulled but once i start to push the choke in it starts to miss and dies. Pulled the fuel line of the carb and cranked the motor and got fuel coming out, so fuel is good. I got a Big Gun slip-on and pro design intake. I looked at the jets for the first time since the dealer jetted it for me and i saw a 155 main and 45 pilot....if that helps.
 

·
Registered
Joined
·
43 Posts
Discussion Starter · #15 ·
okay i got it to idle now, i pulled all three jets again and ran a piece of wire thru them. The problem now is it runs fine until about half throttle then it starts to sputter out and not rev.....:aargh4: any ideas what the problem is now? Ruting rhino said adjust the A/F screw out 2 turns.....wheres that? This thing ran fine at the end of last season......
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top