![]() |
![]() |
This is a discussion on 102.5mm piston kits for 660 Rhinos and Raptors! within the Benchmark Performance forums, part of the Sponsor Forums category; Quote: Originally Posted by AZCourt Quote: Originally Posted by 07fj Quote: Originally Posted by AZCourt Perfect for worcs. They have a 700 and below class, ...
|
|||||||
| Register | Home | Forum | Active Topics | Photo Gallery | Members List | Social Groups | Search | Today's Posts | Mark Forums Read |
| Benchmark Performance Benchmark Performance - Ramona, CA - 760-484-0986 |
![]() |
|
|
LinkBack | Thread Tools | Display Modes |
| Sponsored Links | ||
|
RhinoForums.net is the premier Yamaha Rhino UTV/ATV Forum on the internet. Registered Users do not see these ads. Please Register - It's Free! |
|
|||
|
Faster than my 727 in the race rhino.
I ended up putting it in the family 4 seater this weekend, it hauls ass.The pic and vid were taken with my cell phone while driving home from XMF Scott's house saturday afternoon (I brokeit infor the first 8 miles). Running 25" 4 speeds with 7-8 psi on flat ground with a slight uphill around the 67mph mark. This is the strongest motorI have built for myself, the race rhino will be getting this setup very soon. ![]()
Last edited by AZCourt; 02-08-2010 at 11:00 PM. |
|
|||
|
How much power would an engine like this make on pump gas .I have been thinking of going this route and I will definately be calling you after all the stroker crank horror stories.Want to be sure it lasts more then a couple of rides.
|
|
||||
|
How much power would an engine like this make on pump gas .I have been thinking of going this route and I will definately be calling you after all the stroker crank horror stories.Want to be sure it lasts more then a couple of rides.
__________________
Benchmark Performance 760-484-0986 To view links or images in signatures your post count must be 10 or greater. You currently have 0 signatures. |
|
||||
|
A basic 686 or 693 would be $425 in parts. This would not include a cam or valve springs, which are often done at the same time as a 686. Labor would be about $450 unless you are doing the install yourself.
__________________
Benchmark Performance 760-484-0986 To view links or images in signatures your post count must be 10 or greater. You currently have 0 signatures. |
|
||||
|
A basic 686 or 693 would be $425 in parts. This would not include a cam or valve springs, which are often done at the same time as a 686. Labor would be about $450 unless you are doing the install yourself.
|
|
||||
|
A basic 686 or 693 would be $425 in parts. This would not include a cam or valve springs, which are often done at the same time as a 686. Labor would be about $450 unless you are doing the install yourself.
__________________
Benchmark Performance 760-484-0986 To view links or images in signatures your post count must be 10 or greater. You currently have 0 signatures. |
![]() |
Lower Navigation
|
||||||
|
||||||
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Visitors found this page by searching for these keywords: |
rhino forums piston,RHINO PISTON TO CYLINDER CLEARANCE |
| Thread Tools | |
| Display Modes | |
|
|
|
Checkout the following websites in the UTV Forums Network: UTV Blog - Yamaha Rhino Forum - Polaris RZR Forum - Kawasaki Teryx Forum - RedLine UTV Forum - Arctic Cat Prowler Forum - Honda Big Red Forum - Can-Am Commander Forum |